OzVMX Forum
Marketplace => Wanted => Topic started by: Stewart Allen on September 24, 2009, 08:33:00 am
-
Need a YZ125F kickstarter aftermarket DT type is OK.
-
I will check my box of 125f stuff and see if i have a spare.Where are u located mate?
-
check out the kickstart lever from the RT100 Yammie.
it should fit and is super tiny and functional.
they turn up on ebay pretty often at reasonable prices.
-
There is an aftermarket one for IT175 that works well and only cost about $55
Viper666
-
Hi Thanks guys, Neale do you now what brand the aftermarket one is.
Mxmanic, I am in Sydney.
-
I know wat u meen by money pit i brought one a couple of months ago and havent been able to finish a race meet
-
All I know is the local motorbike shop guy just looked it up in the aftermarket book for everything, fork seal, brake levers, clutch plates etc under kickstarters for Yamaha and there it was. Comes with a rubber foot whatever but it slides off easy enough. Ring me tomorrow and I'll drop into the shop. Pretty sure they are through Monza imports.
Viper666 0427334186
Have found parts to make NOS one, cost about $160-170 inc postage from US?
Either that or I have one of those IT175 ones never used and you can have it for $65 inc postage.
-
I'm told that the aftermarket DT ones are poor quality. New genuine DT levers are ~$80, FWIW.
-
The DT one sounds the go then.
Nathan, are you going to reply to the PM I sent you?
Viper666
-
I want to know where all these kickstarters are going???
I have three 125f engines, none of which came with original kickstarters!
-
Neale, you should know me well enough by now... :-[ Your bits are in a pile, just need to find the time to get them into a box and then to the post office.
Mainy, they break because they're a flawed design.