OzVMX Forum

Marketplace => Wanted => Topic started by: dave on September 16, 2009, 08:45:45 pm

Title: 38mm Mikuni or bits needed
Post by: dave on September 16, 2009, 08:45:45 pm

I've got a stripped 38mm Mikuni for an IT250H/J which is missing bits (most bits!) I need;
- slide spring
- adjuster screw/pipe that goes into the top plus the assorted hardware
- float
*main jet #400
*pilot jet #50
- the plate under the main jet
- the brass ring

Or a complete 38mm Mikuni

Cheers Dave

Title: Re: 38mm Mikuni
Post by: oldyzman on September 16, 2009, 08:52:43 pm

Hey Dave, A while ago i was looking for a carb for my YZ, South west sydney motorcycle wreckers on homepride ave at liverpool, had a 38mm but it was off an IT, a bit different to the yz as it had a brass float opposed to plastic twin floats,
I was lucky to get a yz 250 F '79 one from Nathan...
Brett

Title: Re: 38mm Mikuni or bits needed
Post by: dave on September 16, 2009, 08:58:21 pm

Cheers I'll try ringing them. Did they want lots for it?

Title: Re: 38mm Mikuni or bits needed
Post by: oldyzman on September 17, 2009, 09:19:00 pm

Mate they wanted thirty dollars for it. it was cheaper than the others as it did not have a cable and throttle attached to it, as most of the others in that wreckers do.

Title: Re: 38mm Mikuni or bits needed
Post by: Rossvickicampbell on September 21, 2009, 04:32:32 pm

haven't got them yet (parts that is) and I must admit the phone "etiquette" was pretty ordinary but you could also try www.mikunioz.com.

cheers

Rossco