OzVMX Forum

Marketplace => Wanted => Topic started by: firko on September 05, 2009, 12:29:34 pm

Title: Yamaha 34mm front end.
Post by: firko on September 05, 2009, 12:29:34 pm

I'm looking for a usable set of 34mm forks to suit an MX250/360, DT250/360 or similar. I'm using a conlcal MX250 hub so need fork leg with the right locating tab. These are going on the VMX magazine el Cheapo TM/TS Suzuki which Old School and I are converting to flat track configuration. I want to use Yamaha forks so we can use my 19" conical frong wheel/Carlilse combination without fabricating wheel adaptors etc. I know I'm getting picky but I'd prefer rust free legs.

Title: Re: Yamaha 34mm front end.
Post by: cyclegod on September 05, 2009, 02:29:44 pm

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=350247237682&viewitem=&sspagename=STRK%3AMEWAX%3AIT

Title: Re: Yamaha 34mm front end.
Post by: JC on September 06, 2009, 03:15:31 pm

Mark, you may get away w using Yam sliders on yr Suz forktubes (if the tolerances are agreeable) as they're both 34mm as I recall.