OzVMX Forum

Marque Remarks => Spaniards (Bultaco, Ossa, Montesa etc) => Topic started by: David Lahey on May 30, 2009, 11:38:20 am

Title: Please ID this Bultaco rear hub
Post by: David Lahey on May 30, 2009, 11:38:20 am

I'm stumped by the smaller spoke flange being part of the casting rather than the riveted-on and chromed steel flange

Title: Re: Please ID this Bultaco rear hub
Post by: David Lahey on May 30, 2009, 11:39:06 am

Other side

Title: Re: Please ID this Bultaco rear hub
Post by: Moto on May 30, 2009, 03:02:06 pm

This hub was used for a couple of models of Lobito's Mk4-Mk8?It was a bit lighter than the one you are used to with the chrome bolt on spoke plate.These Lobito,s were more trials orientated bikes.Not sure if they would withstand use in motocross.