OzVMX Forum

Clubroom => Vinduro => Topic started by: mxmaniac on April 30, 2009, 09:49:43 pm

Title: jetting for IT250k
Post by: mxmaniac on April 30, 2009, 09:49:43 pm

Anybody have any reccommendations on improved jetting specs on a standard IT250k? It only has a after market muffler other than that its all standard.

Title: Re: jetting for IT250k
Post by: shortshifter on May 19, 2009, 04:42:19 pm

main jet 380     needle jet n-8  pilot jet 40   jet needle 6f34  clip position 4 float level 24mm.I think I'm running a 390 main jet.

Title: Re: jetting for IT250k
Post by: Tim37 on July 18, 2009, 09:58:35 pm

The best thing to do with ANY Jap bike is...
 remove the petrol cap hold onto this ,wheel into its place any european bike , fit the cap and all will be well with your world , especialy when you ride !cheers Tim

Title: Re: jetting for IT250k
Post by: XR on July 19, 2009, 09:13:11 am

So what your trying to say is, the JAP fuel cap should make the european bike start eventually, and run properly????

Title: Re: jetting for IT250k
Post by: mxmaniac on October 17, 2009, 05:07:54 pm

Thanks fellas