OzVMX Forum

Marketplace => Wanted => Topic started by: subanator on April 08, 2009, 12:54:49 am

Title: DT175 Reed Block + Forks
Post by: subanator on April 08, 2009, 12:54:49 am

Would like a complete DT175 Reed Block to suit '74-'79 model, DT175A to F; Eng No's - 443, 559, 2A7, 2N5.
Pair of good inner forks tubes also.

Cheers,
Roger

Title: Re: DT175 Reed Block + Forks
Post by: Nathan S on April 08, 2009, 10:08:10 am

The alloy reed block or the rubber boot? Or both? I can help with a good reed block, and with useable (not great) rubber boot.

Fork tubes are hard to find - even if they're not rusty, they wear off chrome down low.
I suspect that later AG100s (the beige or red ones with the leading axle forks) share the same inner tubes as the earlier DT/AT/CT/AGs. If this is correct, it will make life a lot easier...

Title: Re: DT175 Reed Block + Forks
Post by: subanator on April 09, 2009, 12:10:19 am

Thanks Nathan, I will take you up on that - block and boot.  ;D
Good tip on the forks, might look into that one, re chroming is too costly for hard chrome.
Send me dome details/price via a PM please.

Seen a brand new AG100 at Yamaha dealer the other week, just like the 1970's version nothing much changed from the CT, a new current model vintage!

Cheers,
Roger

Title: Re: DT175 Reed Block + Forks
Post by: Freakshow on May 21, 2009, 01:58:06 pm

i have 2 pair of 175 forks wiith the leading legs, looking to swap for mx125 or 250 legs if your interested or enough cash for me to buiy some :O)