OzVMX Forum

Marketplace => Wanted => Topic started by: Tornado on March 28, 2009, 08:48:12 pm

Title: RM250T (1980) wanted
Post by: Tornado on March 28, 2009, 08:48:12 pm

Looking for a 1980 RM250T (2 actually) , will consider incomplete bikes.

any help would be appreciated.

regards

Tex

Title: Re: RM250T (1980) wanted
Post by: E74 on March 29, 2009, 08:55:26 am

I hope you get one soon Tex.. ;)

Title: Re: RM250T (1980) wanted
Post by: oldfart on March 29, 2009, 08:58:05 am

You will need three  ;D    swing arms suffer from chain buffer rash on ( top side )  gear boxs are a bit worn out at this stage . And if the LHS case is dam near imposssible to obtain ( if the clutch actuator has gone west)

Title: Re: RM250T (1980) wanted
Post by: E74 on March 30, 2009, 11:42:16 pm

Get a Honda instead.. ;D

Title: Re: RM250T (1980) wanted
Post by: LWC82PE on March 30, 2009, 11:52:01 pm

you could always fit a PE bottom end. cases for them are not too hard to find, and the RM top end will bolt right  onto the PE bottom.

Title: Re: RM250T (1980) wanted
Post by: Tornado on March 31, 2009, 07:33:38 am

Informative opinions have been taken on board with 1 bag of salt and after careful consideration promptly cast aside. For those that wonder why I want such a heap of %^$^ well lets just say that the good lord is too busy to punish me right now for the things I have done as a very bad man and I am looking at doing it on his behalf . The second required motor driven contraption is so I can punish someone else who shall remain nameless but for now lets call him Phil Catton who has gone on and on most of his speaking life on this terra firma about how good he was back in the day.

I have one lead so far from this wonderful electronic book thing with a typewriter attached, and how you all fit inside has me perplexed.

I must away to Pramulate and perhaps pick up some medicinal snuff on my jouney.

I am good..just one letter from God 

Title: Re: RM250T (1980) wanted
Post by: mainline on March 31, 2009, 10:25:53 pm

best reply i've read for a while

Title: Re: RM250T (1980) wanted
Post by: Tornado on April 05, 2009, 10:05:16 pm

One RM250T and a 250N on their way. many thanks, pics will be provided when they arrive.