OzVMX Forum

Marque Remarks => Husqvarna => Topic started by: JC on February 16, 2009, 05:42:39 pm

Title: 73-74 WR175 std bore
Post by: JC on February 16, 2009, 05:42:39 pm

Can anyone tell me the std bore size for the early WR175 Husky engines (73-74) pls?

(NOT the later CC/GP175 of 75-76, which is a completely diff engine)

Title: Re: 73-74 WR175 std bore
Post by: evo550 on February 16, 2009, 07:13:37 pm

Try here JC
http://www.huskyclub.com/piston.htm

Title: Re: 73-74 WR175 std bore
Post by: holeshot buddy on February 16, 2009, 11:36:09 pm

without looking at anything i will guess 63mm ;D

Title: Re: 73-74 WR175 std bore
Post by: evo550 on February 17, 2009, 12:04:00 am

Russ,
Your almost a mill out either way ;)

Title: Re: 73-74 WR175 std bore
Post by: holeshot buddy on February 17, 2009, 12:09:06 am

must be the way i was holding my tounge :P :P ;D

Title: Re: 73-74 WR175 std bore
Post by: JC on February 17, 2009, 09:20:51 am

Many thanks Evo,
I had looked on the Husky club site but didn't spot that chart.