OzVMX Forum

Marque Remarks => Yamaha => Topic started by: yzhilly on September 19, 2007, 11:02:47 pm

Title: IT250K
Post by: yzhilly on September 19, 2007, 11:02:47 pm

Well i just fired up the IT250K . thanks Nathan for all the bits ,the engine came up real nice . Shes still a bit ugly but just needs plastics i will post some pics of it here. Just wondering has anyone seen a offset triple clamp for 43mm forks ?.  I want drop the forks through the clamps I'm trying to get it a bit lower as the missus cant touch the ground on it. Also how do you post a link to a video i've got one of the IT465 on the dyno.

Title: Re: IT250K
Post by: Freakshow on September 19, 2007, 11:08:14 pm

post your video to YOUtube or similar like photovillage.  anything that holds vids - then just post the hot link in here !

Title: Re: IT250K
Post by: yzhilly on September 19, 2007, 11:15:52 pm

Thanks Freaky hey what was that line in one of your post . trust me !!!. have you gone legit ??? what tha  .How many flattrackers have you got.?

Title: Re: IT250K
Post by: yzhilly on September 20, 2007, 11:13:43 am

http://<embed width="448" height="361" type="application/x-shockwave-flash" wmode="transparent" src="http://i204.photobucket.com/player.swf?file=http://vid204.photobucket.com/albums/bb130/yzhilly/PIC_0050.flv"></embed> Here it is not sure how it turns out ,but if it works it's easy . So c'mon YZ250H where is the YZ125 ?.

Title: Re: IT250K
Post by: Nathan S on September 20, 2007, 12:55:05 pm

Hilly, YZ465/250H has the top triple clamp with the rearward mounted bars + 43mm forks.
The original forks on these bikes are super long and are expected to be run with ~65mm of the fork sticking above the top triple clamp.

Triple clamp off-set is the same as YZ250s at least until 1983 (not YZ125s - the 125 forks are a few mm closer together). Don't know about IT clamps though.

I'm looking for one so I can fit some 465 forks to my YZ250G.

Title: Re: IT250K
Post by: yzhilly on September 20, 2007, 01:07:45 pm

I think i will just have to get her a IT175, coz the 250 is gonna be a good thing and i dont want to knobble it to suit her . i could swap the IT465H front end ,38mm long forks and rear clamps . I wonder if the spec wuold be the same for IT465H ,coz it's raked like a chopper with long forks they look like there flexing sitting on the stand .

Title: Re: IT250K
Post by: YZ250H on September 20, 2007, 01:33:00 pm

Yeah, righto - I'll get that video for you - hopefully I can catch her stopping as well.  My missus looked at me funny when I asked her to video me on the bike  ;D.