OzVMX Forum

Clubroom => General Discussion => Topic started by: E74 on February 07, 2009, 06:15:16 pm

Title: Hand made Pipes
Post by: E74 on February 07, 2009, 06:15:16 pm

I am after someone preferably in Sydney to make me some hand made cone pipes,  Any Suggestions?, I know Frank Pons used to make them back in the 80's but I don't know if he still does it?

Title: Re: Hand made Pipes
Post by: hotdog1975 on February 07, 2009, 07:10:53 pm

I think your best bet would be Geoff Morris Concepts (GMC) he's in Vic, he already has a large selection of MX & Vinduro pipes to choose from, all made from cones & fabbed up.

Title: Re: Hand made Pipes
Post by: E74 on February 07, 2009, 08:07:21 pm

Hmmm, that makes it a real expensive exersize, the one I want made is a custom for a bit of an oddball combination, may just have to do it however... ???

Title: Re: Hand made Pipes
Post by: hotdog1975 on February 07, 2009, 09:44:36 pm

Please explain..?? have you worked out the tuned length of this "pipe" to be made & diameters required or are you just having a play around with some ideas..??

Title: Re: Hand made Pipes
Post by: E74 on February 07, 2009, 09:47:44 pm

I have a 83 model CR125 with a ,84 model Crank, clutch cover, Mugen head,barrell and ATAC powervalve fitted to it, so now that I think about it, a 1984 CR125 Pipe should do the job,..... :-\

Title: Re: Hand made Pipes
Post by: Lozza on February 07, 2009, 10:45:13 pm

Easy done. Send me a pm