OzVMX Forum

Clubroom => Tech Talk => Topic started by: MX? on January 21, 2009, 08:42:37 pm

Title: Making rear brake torque arm for XL 250/350 ?
Post by: MX? on January 21, 2009, 08:42:37 pm

Hi all,
Looks like I'm going to have to make up a brake support for the 250 with 350 (longer) swingarm. So the question is: Is there and critical angle of the dangles that need to be considered concerning the length of the arm? or is it only a matter of ensuring that cables/actuating arms all look happy.
Unless one of you kind souls with an XL350 care to give me a measurement? Thanks 

Title: Re: Making rear brake torque arm for XL 250/350 ?
Post by: Colin Jay on January 22, 2009, 03:44:47 pm

The distance between the centre of the hole in the brake torque arm for the XL350 setup that I have in the rear of my 250 is 280mm, compared to 230mm for the arm from the std 250 setup.

CJ

Title: Re: Making rear brake torque arm for XL 250/350 ?
Post by: MX? on January 22, 2009, 08:40:05 pm

Thanks for doing that CJ.  :)
Should save some dicking around.