OzVMX Forum

Clubroom => Tech Talk => Topic started by: evo550 on November 06, 2008, 02:06:25 pm

Title: 35 t press in brissy.
Post by: evo550 on November 06, 2008, 02:06:25 pm

Anyone know of a 35ton press in brisbane to press out crank pin ??
Serco have tried but only go to 20t and didn't budge it.

Title: Re: 35 t press in brissy.
Post by: vandy010 on November 06, 2008, 11:18:13 pm

PM sent

Title: Re: 35 t press in brissy.
Post by: maicomc490t on November 08, 2008, 11:21:56 am

If you get stuck send it on down to Sydney - my 35T makes short work of most anything and I have a good range of platten plates to suit most cranks and can always cut more if required.
Cheers
Dave Mac

Title: Re: 35 t press in brissy.
Post by: TT5 Matt on November 11, 2008, 12:10:24 am

got a pic or drawing of a plattern plate so i can make one at tafes machining hobby course [homer course] that i attend.



TT5 Matt