OzVMX Forum

Marque Remarks => Spaniards (Bultaco, Ossa, Montesa etc) => Topic started by: slider84 on November 04, 2008, 01:58:38 pm

Title: bultaco reed valve
Post by: slider84 on November 04, 2008, 01:58:38 pm
does any one have a reed valve from a late modle pursang 250.
[email protected]
Title: Re: bultaco reed valve
Post by: montynut on November 04, 2008, 09:39:07 pm
Hey Ross,
Have you found out which model KTM the reed block assembly comes from for the 250H7? Please please please!!
Title: Re: bultaco reed valve
Post by: slider84 on November 05, 2008, 10:51:06 am
the bolt pattern is 35 x 70. can you post a pic of the ktm block.
Title: Re: bultaco reed valve
Post by: montynut on November 05, 2008, 07:15:08 pm
Ross,
Sounds like your H7 is the same as mine. The rubber connector to the carbie is original. At this stage it appears OK but I am afraid to touch it as I think it would probably fail if I do. The actual reed block seems OK.
Title: Re: bultaco reed valve
Post by: mx250 on November 06, 2008, 02:30:09 pm
the bolt pattern is 35 x 70. can you post a pic of the ktm block.

I don't know the model number but my Monty reed looks like.....

(http://i323.photobucket.com/albums/nn458/mx250syd/reed2.jpg)

(http://i323.photobucket.com/albums/nn458/mx250syd/reed.jpg)
does that help ??? ::)
Title: Re: bultaco reed valve
Post by: mx250 on November 06, 2008, 08:42:20 pm
Yup. That's the one. Is that connector any good Graeme and how much?
Its a good 'un Rooss but sorry, it's a keeper. Without it it would make the whole engine pretty useless ::).

I didn't mean to be a tease but rather to help along the discussion to identify the Monty reed :-[.