OzVMX Forum

Marque Remarks => Yamaha => Topic started by: klxNev on October 15, 2008, 11:32:24 am

Title: YZ125F question
Post by: klxNev on October 15, 2008, 11:32:24 am

Just wondering will the barrell and head off a 125G will fit on a 125F bottom end. Thanks.

Title: Re: YZ125F question
Post by: cyclegod on October 15, 2008, 11:44:27 am

NO the "F" is centre port exhaust and the "G" is left side port exhaust

Title: Re: YZ125F question
Post by: Nathan S on October 15, 2008, 11:14:37 pm

Correct. And the spacing of the studs that hold the barrel to the cases is different too.

You can fit YZ-D/E top ends, along with monoshock DT125/175 top ends, or IT175 before 1980. Or IT125.

The earlier YZ and the DT parts will both require a different exhaust pipe (or mods to make the F pipe fit).
IT125 barrell will take an unmodified F pipe.
Not sure about IT175 bits (but I think they require mods).

Apparently a YZ125E top end and pipe is the hot set-up to avoid the peakiness of the standard F.

Title: Re: YZ125F question
Post by: cyclegod on October 16, 2008, 12:03:55 am

Quote from: Nathan S on October 15, 2008, 11:14:37 pm

Not sure about IT175 bits (but I think they require mods).

IT175F is a bolt on fit as the barrel casting is the same, just different boring diameters for the sleeves.
Bfore the first IT125 was available (125G) it was a gun setup to convert a 175 to a 125 with a barrel swap (works for E & F models)