OzVMX Forum

Marketplace => Wanted => Topic started by: Canam370 on May 28, 2022, 09:45:33 pm

Title: WANTED. Forks to suit PE250B
Post by: Canam370 on May 28, 2022, 09:45:33 pm

ISO forks to suit a PE250B. RM250a/b and RM370 will also suit. Good chrome preferred but not essential. Whatcha got?

Title: Re: WANTED. Forks to suit PE250B
Post by: LWC82PE on June 19, 2022, 06:37:42 pm

Incase you don't know the PE forks are different to the RM. All the parts are different. Different length  damping rods, sliders, inner tubes, springs, travel

Title: Re: WANTED. Forks to suit PE250B
Post by: Canam370 on June 24, 2022, 07:15:13 pm

All sorted. Used RM stanchions. All the PE bits fitted.

Title: Re: WANTED. Forks to suit PE250B
Post by: LWC82PE on July 01, 2022, 08:16:03 pm

PE250B

Slider – 345mm
Inner – 660mm


76/77 RM250 A/B

Slider – 355mm
Inner – 647mm


Fitting RM inner tubes will lower the front end. Probably not a good idea unless fitting shorter than standard shocks as well,  as the PE is already low at the front and kinda hunched forward in stock form. Check clearance between triple clamp, wheel and top of sliders for clearance when forks bottomed out.