OzVMX Forum
Clubroom => Tech Talk => Topic started by: dirtrumpy on May 02, 2018, 10:25:26 pm
-
Does anyone here have the specs for a mikuni 6dh20 jet needle? Can't find it anywhere, mikuni oz can't help either.
-
Do you mean 6DH2 ? = 62.3 mm long. If so i have specs and can send (from old Mikuni manual)
-
No, it is the 6dh20 im after, mikuni oz have them in stock but strangely don't know the specs for them, can't find anywhere on the net either
-
Seems the 500cc Husky 1984 runs that needle. Seonosale says they have them and some on e/bay - perhaps see if those firms can give you specs?
-
No, it is the 6dh20 im after, mikuni oz have them in stock but strangely don't know the specs for them, can't find anywhere on the net either
What’s the cost of one?
-
Only around $15 and already on order. Just wondering where it sits relative to the others.
-
6DH20 is not a Husky 500 needle (7DH3). It is however used in some CR/WR125's & CR/XC250's. I don't have the specs but last time I checked one against the common Husky 6DH3 needle, it was longer by an obvious amount. I used one in a CR430 which would normally use a 6DH3 & it seemed to clean up the bottom & mid.
Cheers,
K
-
apologies husky rider said thats what his 84 needle was
-
No apologies required, his 500 may have one in it but it's not standard issue for 500's. I don't reckon it would work that well in VM40 or VM44 though, they generally require 7 series needles.
K