OzVMX Forum

Clubroom => Tech Talk => Topic started by: 1983_Enduro_YAMI on April 23, 2018, 09:30:50 pm

Title: Flatslide TM38 in '82 YZ250
Post by: 1983_Enduro_YAMI on April 23, 2018, 09:30:50 pm

G'day all,

I have purchased an TM38 carby for my '82 YZ250 recently to replace the old VM round slide. What's the best initial jetting for this?? Can i use the jetting from the '82 RM250 as it was equipped with flat slide from the factory..then later on i will fine tune it according to the preference of the motor.

Title: Re: Flatslide TM38 in '82 YZ250
Post by: Momus on April 25, 2018, 05:22:43 pm

Reasonable starting point IMO, though case reed Suzuki versus cylinder induction might make a bit of difference.