OzVMX Forum

Marque Remarks => Honda => Topic started by: 090 on August 28, 2007, 09:16:24 pm

Title: CR125M stator cover
Post by: 090 on August 28, 2007, 09:16:24 pm

Between one '74, two '75's and three motors,there is not one set of cases or one stator cover that wasn't smashed to bits. Obviously it is a common problem, what i want to know is it just a maintenance issue, or is it a design fault that has a cure? I just acquired an intact sidecover, but i don't want to put it on until i am reasonably sure it wont get smashed to smithereens

Title: Re: CR125M stator cover
Post by: Noel on August 29, 2007, 08:33:13 am

Yep common fault right through to 77
my bike came intact but was warned of problems,
so I put on extra chain guides and a roller mounted to the side stand bracket
will post pictures to night.
Noel

Title: Re: CR125M stator cover
Post by: Quicksilver on August 29, 2007, 10:39:19 am

My first 1974 CR125m i had in late 1970s was gone their 090. So had most others around at that time. Soon as chain derails or breaks side cover takes a hit. Bikes that have that area intact were those that were maintained and looked after or had little use.

Title: Re: CR125M stator cover
Post by: Noel on August 29, 2007, 10:33:53 pm

Here are some pictures,
also planned to put a top guide case saver above chain off rear engine mounts
 but haven't got around to that yet
(http://i77.photobucket.com/albums/j41/Tento850/DSCF2251.jpg)
(http://i77.photobucket.com/albums/j41/Tento850/DSCF2253.jpg)
VCheers
Noel
Note to self (clean the chain before next meeting)

Title: Re: CR125M stator cover
Post by: 090 on August 30, 2007, 06:37:02 pm

Thanks for the pic's Noel. I shall do the same mod on the '74 and '77. Cheers,Brad