OzVMX Forum
Marque Remarks => Other Makes (CanAms, Coopers, etc) => Topic started by: Husky500evo on November 27, 2016, 05:45:58 pm
-
I am in need of a new conrod kit to suit a '75 Can AM TNT250. Does anyone out there know of an alternative option that will do the job , as I am told that the original Rotax rod kit is no longer available ?
-
Do Can am use the type 244 rotax engine?
-
Emailed you Mark.
-
Not sure if the TNT motor is called a 244 Rotax . I just know that they are a shorter stroke than the ones used for the MX4 and later Can Ams and ATKs etc .
-
Not sure if the TNT motor is called a 244 Rotax . I just know that they are a shorter stroke than the ones used for the MX4 and later Can Ams and ATKs etc .
yeah, that's where I was headed with that. Have you tried Bert Floods?
-
A 120mm or 125mm rod ? Have you tried Tony Murphy in the USA?
-
Was told that Bert Flood doesn't have any Rotax stuff left . I have emailed Tony Murphy . I have a good crank , which I think is from an MX6 Can Am 250 , which has a rod that is about 5 mm longer than the one I need .
-
They still have engine stuff left - just not Canam stuff.
-
Was told that Bert Flood doesn't have any Rotax stuff left . I have emailed Tony Murphy . I have a good crank , which I think is from an MX6 Can Am 250 , which has a rod that is about 5 mm longer than the one I need .
Floods still has Rotax parts for the old 2t motorcycle engines. Just bought some gear there last week, ordered one day, delivered the next.
-
OK , I will give Bert Floods a try , as well . Thanks for the heads up .
-
I'm sure I've seen new rods on one of the Can Am/ SWM sites I've perused over the years. One of the USA sites but can't remember which one. Might be worth a google & some browsing.
K
-
https://shop.brp-rotax.fr/en/
-
I ended up buying a TNT250 rod kit and some other Rotax bits from Tony Murphy in the USA . Al Roberts , in Texas , has rod kits as well . But they are no longer available from Rotax .