OzVMX Forum

Marketplace => Dealers => Topic started by: Lozza on April 19, 2016, 09:31:34 am

Title: Wiring Looms
Post by: Lozza on April 19, 2016, 09:31:34 am

Built up an extensive collection of OEM style connectors (as well as bullet and spade) , a mountain of various coloured wire and loom tape. Should be able to replicate most looms from a sample.

Title: Re: Wiring Looms
Post by: Lozza on April 19, 2016, 01:04:01 pm

Sure no problem if you supply the plugs all soldered too

Title: Re: Wiring Looms
Post by: Hoony on April 19, 2016, 06:47:16 pm

what's a Deutsch Plugs....sounds a bit rude

no seriously what are they ?

Quote from: Wasp on April 19, 2016, 11:36:43 am

Lozza , just seen this post at the right time . I was looking for someone that can make me one for a H2 and two for H1 to finally finish them off  . If you dont have Deutsch Plugs , I could supply them . Can do ?

Title: Re: Wiring Looms
Post by: Hoony on April 19, 2016, 08:20:58 pm

Thanks Walter, you Learned me  ;)

good old German engineering at its best !

Title: Re: Wiring Looms
Post by: Lozza on April 20, 2016, 09:22:13 am

(https://www.corsa-technic.com/item_images/MT-2S-3.jpg)

Sumitomo are very good as well, cheaper plugs seem to have lots of little parts  and difficult to get apart