OzVMX Forum

Marketplace => For Sale => Topic started by: Nathan S on August 07, 2008, 09:38:37 pm

Title: DT250 and 400 monoshock hubs.
Post by: Nathan S on August 07, 2008, 09:38:37 pm

I have the rear hubs from each of these bikes
Bare hubs only, although I might have the spokes for the 400.
Good useable condition.

The 250 hub is similar to the earlier MX250A type hub (NB: Not the same - they take a different sprocket) and would be an easy way to get rid of the cush drive on a DT250/360A.

Come and take 'em away or they end up in the scrap pile.

04000 23847

Title: Re: DT250 and 400 monoshock hubs.
Post by: Nathan S on August 08, 2008, 11:12:15 pm

250 hub claimed by Vandy.

400 hub still available.

Title: Re: DT250 and 400 monoshock hubs.
Post by: firko on August 08, 2008, 11:25:08 pm

Gone Nathan.......I'll have that 400 hub if you don't mind. Do you have a spare backing plate as well? If so, I woulldn't mind it.

Title: Re: DT250 and 400 monoshock hubs.
Post by: vandy010 on August 09, 2008, 12:04:44 am

if Nathan hasn't got a backing plate i'll probably have a DT400 one here somewhere. will look over the weekend.

Title: Re: DT250 and 400 monoshock hubs.
Post by: Nathan S on August 10, 2008, 10:28:57 pm

Sorted Firko. Pretty sure I don't have a monoshock backing plate (lug rather than torque arm), but probably have a twin-shock one. Will check tomorrow.

Title: Re: DT250 and 400 monoshock hubs.
Post by: vandy010 on August 12, 2008, 01:02:16 pm

found a backing plate, PM sent to firko

Title: Re: DT250 and 400 monoshock hubs.
Post by: Nathan S on August 12, 2008, 06:15:21 pm

Quote from: Nathan S on August 10, 2008, 10:28:57 pm

Sorted Firko. Pretty sure I don't have a monoshock backing plate (lug rather than torque arm), but probably have a twin-shock one. Will check tomorrow.

Funny that... turns out that I do have the monoshock brake, but no spare twinshock ones.