OzVMX Forum

Marque Remarks => Spaniards (Bultaco, Ossa, Montesa etc) => Topic started by: Tahitian_Red on August 02, 2008, 07:15:19 am

Title: New Bing 54 Carbs?
Post by: Tahitian_Red on August 02, 2008, 07:15:19 am

Are there any suppliers for NEW Bing 54 carbs? 

Someone on eBay sells new aircraft Bings, but they have a stange looking spigot.

Title: Re: New Bing 54 Carbs?
Post by: aussieatk on August 03, 2008, 09:09:28 pm

Red, try Penton parts or Randall@RTR Moto they deal in Bing Parts

Aussieatk

Title: Re: New Bing 54 Carbs?
Post by: mike1948 on August 05, 2008, 06:07:45 pm

I picked a new Bing 54 off ebay, $129US, complete with slide & spring.  Fitted my main & pilot jets, needle etc.  Bike runs clean, but later model bing must have a longer needle, if I wind full throttle(with engine off), needle lifts too high & can cause slide to jam up.  Slide for same 36mm carb is much larger diameter as well.  If I can sort the needle business, it will be a pretty good buy, I like the Bing carbys, except they piss out fuel at times on my newly painted cases!

Title: Re: New Bing 54 Carbs?
Post by: Tahitian_Red on August 06, 2008, 01:41:36 am

Mike,

What bike did you fit it to and did spigot seal up well to the intake?

Title: Re: New Bing 54 Carbs?
Post by: mike1948 on August 06, 2008, 09:16:55 am

I put it on my VB360, perfect fit both ends.  Only major difference I can see is the choke mechanism instead of a tickler for cold starting.