OzVMX Forum

Marketplace => Wanted => Topic started by: micko on July 12, 2015, 08:00:15 pm

Title: Wanted : RM250A/B centre engine case gasket
Post by: micko on July 12, 2015, 08:00:15 pm

As it says, desperate for one.

Title: Re: Wanted : RM250A/B centre engine case gasket
Post by: Tomas on July 12, 2015, 09:34:09 pm

would not be hard to make one from sheet of gasket paper. centre gaskets are usualy 0.4 mm thick. used to make centre case gaskets for my jawa 50. never had a leak. give it a go

Title: Re: Wanted : RM250A/B centre engine case gasket
Post by: Nipper on July 13, 2015, 08:57:21 am

Pretty sure they are still available. Part number 11481-41101.
Give your local Suzuki dealer a call.

Title: Re: Wanted : RM250A/B centre engine case gasket
Post by: micko on July 13, 2015, 04:18:22 pm

Unfortunately Nipper there backorder ex japan. Might have to make one as Tomas said.

Title: Re: Wanted : RM250A/B centre engine case gasket
Post by: micko on July 13, 2015, 06:00:26 pm

All sorted, found 1 at Mick Hone  :)

Title: Re: Wanted : RM250A/B centre engine case gasket
Post by: Doc on July 13, 2015, 06:33:27 pm

On a side note..if you do make your own centre gasket the thickness many early suzukis use is 0.60mm. Anything else may cause shifting issues ;)

Title: Re: Wanted : RM250A/B centre engine case gasket
Post by: micko on July 21, 2015, 07:52:45 pm

Found that out on my 370 Doc, put it together without a centre gasket and found the shift drum stuck out of the case a wee bit to far (gasket thickness) and rubbed on the locating plate. Damm, I wasn't pulling it apart again.  A bit of recessing/grinding on the inside of the locating plate fixed that baby.