OzVMX Forum

Marque Remarks => Husqvarna => Topic started by: Tossa on June 08, 2015, 12:19:49 pm

Title: Wanted Piston Pin Washers
Post by: Tossa on June 08, 2015, 12:19:49 pm

Wanted Piston Pin washers for 1974 CR250

cheers

Barry

Title: Re: Wanted Piston Pin Washers
Post by: Brian Watson on June 08, 2015, 05:58:42 pm

Barry, as mentioned on the phone, we are not using the spacers when using a Woosner or Wiseco piston... anyone else using them??..we aren't..

Title: Re: Wanted Piston Pin Washers
Post by: Tossa on June 08, 2015, 06:21:25 pm

they were in the MAG when Paul took it apart and he placed them in the 79  so that one is ready to go and now would like to place some back in the MAG

Title: Re: Wanted Piston Pin Washers
Post by: grouty on June 08, 2015, 06:31:33 pm

If you are using Wossner pistons, you won't need the silly little alloy spacers. They have a narrower gap for the little end.
My 390's run 18mm dia small end pin. I use a genuine Kawasaki small end bearing. This fits perfectly between the bosses in the piston.