OzVMX Forum
Marketplace => Wanted => Topic started by: TJR426 on December 09, 2014, 12:59:37 pm
-
Wanted new or used front brake cable for MX360. Thanks
-
Should still be able to buy one over the counter at your local Yammie shop..
Just check whether the brake backing plate is 6mm or 8mm thread as most early YZ/IT & some DT/XT cables should fit...
Just different lengths is all...
-
Go to steves motocycles he supports your club and he is close to you in
Midland
-
Thanks, I will go to Steves, for some reason I thought it would be harder to
find
-
If not I probably have one. Should have bought my MX360 doesn't need anything!!
-
AG 200 will more or less be the same
-
except it was not going tossa what was or is the problem with it ;)
-
Long story but will be fixed this weekend with new piston ring, pin and clips. gaskets. Apparently dropped new ring, I thought it was electrical, but there you go all good
-
never said you were a mechanic!
-
Nice Rossco, thank you for your support!!lol
-
mrT (mr tossa) that husky is nearly two full bikes I will go look this week hoping the one motor is a wr
-
where is it