OzVMX Forum

Marque Remarks => Kawasaki => Topic started by: Moto on December 08, 2014, 09:22:06 pm

Title: 83 -84 KX 250 Swing arm
Post by: Moto on December 08, 2014, 09:22:06 pm
Would any one be able to measure up a 83/84 KX 250 swing arm for me.I want to use one on a project and need to know if it is close to fitting.

Inside distance between the wheel end.
Outside distance at the swing arm pivot end.
Gap between the swing arm pivot bearings.
Length of pivot bearing housings 
Length from swing arm pivot  centre to very end of the arm.
Axle size.

Thanks.
Title: Re: 83 -84 KX 250 Swing arm
Post by: Hardo on December 08, 2014, 09:32:14 pm
I can easily answer all that for both 83 and 84 tomorrow mate. I have both an 83 and an 84 KX250 swingarm here.

 :)
Title: Re: 83 -84 KX 250 Swing arm
Post by: Hardo on December 11, 2014, 09:38:06 pm
Okay, this is what I measured:

83 KX250 Swingarm (Gold):
1. Inside distance between the wheel end = 219mm (outside at wheel end is 240mm)
2. Outside distance at the swing arm pivot end = 192mm
3. Gap between the swing arm pivot bearings = 112mm
4. Length of pivot bearing housings = 40mm
5. Length from swing arm pivot  centre to very end of the arm = 625mm
6. Total length = 641mm

84 KX250 Swingarm (silver):
1. Inside distance between the wheel end = 203mm (outside at wheel end is 264mm)
2. Outside distance at the swing arm pivot end = 192mm
3. Gap between the swing arm pivot bearings = 112mm
4. Length of pivot bearing housings = 40mm
5. Length from swing arm pivot  centre to very end of the arm = 631mm
6. Total length = 648mm


Hope that helps mate,
Hardo  :)
Title: Re: 83 -84 KX 250 Swing arm
Post by: Moto on December 12, 2014, 01:13:38 pm
Thanks for the great info Hardo :)
Title: Re: 83 -84 KX 250 Swing arm
Post by: Hardo on December 12, 2014, 08:42:04 pm
 ;)
Title: Re: 83 -84 KX 250 Swing arm
Post by: ELC hunter on December 31, 2014, 08:42:23 am
Tony I could drop one round to you if you need to eyeball one in person.
Title: Re: 83 -84 KX 250 Swing arm
Post by: Moto on December 31, 2014, 08:14:35 pm
Thanks Gav,I will be in touch