OzVMX Forum

Marketplace => Wanted => Topic started by: 2stroksmoka on November 14, 2014, 08:34:33 am

Title: 1989 cr125 cylinder
Post by: 2stroksmoka on November 14, 2014, 08:34:33 am

Looking for one with original bore, no sleeve. PM if you have one please

Title: Re: 1989 cr125 cylinder
Post by: Simo63 on November 14, 2014, 09:47:38 am

Pretty sure they were Chrome or Nicasil bore standard

Title: Re: 1989 cr125 cylinder
Post by: 2stroksmoka on November 14, 2014, 11:41:35 am

Yeah they are nikasil. Mine has had an ugly steel sleeve put in it causing a a bad head gasket leak. It's pretty much a throw away cylinder now and I am not a sleeve fan to begin with anyway. I think the 88 cylinder is identical

Title: Re: 1989 cr125 cylinder
Post by: CRTAD313 on November 14, 2014, 02:29:00 pm

I have one. Came off running bike but does have wear. I managed to get a nos replacement cheaper than refurb.Don't think 88 is nicasil , 88 had a genuine oversize piston available 89 doesn't .

Title: Re: 1989 cr125 cylinder
Post by: 2stroksmoka on November 14, 2014, 05:04:19 pm

Where did you get NOS from? Only place I can find is csml and it would be over $900 after conversion and postage.
Where are you located? I will PM you my email for some pics

Title: Re: 1989 cr125 cylinder
Post by: CRTAD313 on November 14, 2014, 05:57:29 pm

Came from the states, must have been one of the last. Now they list it as unavailable.   Cylinder is standard bore not sleeved, could be used but I would recommend having the nicasil redone. 87/88 same cylinder but not nicasil, 89 is.