OzVMX Forum
Marque Remarks => Spaniards (Bultaco, Ossa, Montesa etc) => Topic started by: matcho mick on July 11, 2014, 01:56:21 am
-
geezas,who designs a bike where you havta lift the motor off its mounts to facilitate rear fugging brake cable anchor point detachment,now, coz it's cradle frame i can't lever the mount bolts back in position,well the bottom ones back in,wooppie the tops 1/2 a fugging hole out >:(,,maybe better luck laterrrrrr zzzzzzzzzzzzzzzzzz
-
I use a ratchet strap around the frame to lift the motor and therefore balance them and fiddle around.
Patience, patience.
-
Better get the riggers spike and hammer out Mickey.....surely its not the OSSA??
(Bultaco would never have done this sort of shoddy design.....just something else just as painful!)
-
ha,actually Macca was using riggers podge bar,(pig sticker),all good slept onit ::),swapped the short explorer s/arm out for a longer pioneer one,hence the necessary brake cable swap,was too nervous in the paddock sections,(great in the narly stuff),so this weekend at bula vinduro was the big test,longer wheel base was a winner,so was the whole weekend,heaven vinduro's just get better,even did a lap on the dirt track ossa,bloody h/bars were a tad too wide in the cow tunnel section,but had to try,(memo to self) gotta build a super pioneer, :P