OzVMX Forum
Marque Remarks => Husqvarna => Topic started by: Brian Watson on May 28, 2014, 10:36:12 am
-
Have been trying to get a couple of M12 x 1.00mm nyloc nuts for the swing arm pivot on the 83 510 ....can't seem to find them anywhere..any leads..??
-
Thats is a very fine thread for that size nut ?, most are going to be 1.75mm coarse thread or 1.25mm fine thread, you might have to go to the dealer for those or try a fastner specific store who can measure the thread.
-
They are for the swingarm pivot.. specifies m12 x 1.0mm in the parts book.. I understand that in suspension setups this is what has been used..may go along the line of this..one of the guys in the club here sells/makes bolts..he is going to make me a new pivot shaft , with m12 x 1.25.. nylocs are readily available for that size.. :D
-
You can get them from Philip at husqvarna-parts.com He has them in stock for $3.50 each.