OzVMX Forum

Marketplace => Wanted => Topic started by: SlideRulz on February 20, 2014, 10:12:04 pm

Title: B50 Cylinder Head Complete.
Post by: SlideRulz on February 20, 2014, 10:12:04 pm

As the heading say's for a DT Slider project.
Gold diggers need not apply. ;) ;D

Title: Re: B50 Cylinder Head Complete.
Post by: jimg1au on February 20, 2014, 10:40:56 pm

the only gold digging will be you into your pockets to pay for one
cheers

Title: Re: B50 Cylinder Head Complete.
Post by: FourstrokeForever on February 21, 2014, 08:04:16 am

They don't come up very often and when they do, they seem to go for a lot of money....good luck finding one.

Title: Re: B50 Cylinder Head Complete.
Post by: SlideRulz on February 21, 2014, 09:14:21 pm

I'm lucky Jim don't have the last one left then. :o :'(
Probably been answered before but can a B40/44 head be adapted to fit?

Title: Re: B50 Cylinder Head Complete.
Post by: Lewis on February 21, 2014, 10:17:21 pm

You could try EV Engineering in the states.I've found Ed to be a great guy to deal with and he supplied every part I needed for my BSA rebuild.I'd be trying him for a cylinder head.

Title: Re: B50 Cylinder Head Complete.
Post by: SON on February 22, 2014, 12:32:13 am

Stan Millard builder of the fastest B50 engines

Title: Re: B50 Cylinder Head Complete.
Post by: FourstrokeForever on February 22, 2014, 09:27:42 am

Quote from: SlideRulz on February 21, 2014, 09:14:21 pm

I'm lucky Jim don't have the last one left then. :o :'(
Probably been answered before but can a B40/44 head be adapted to fit?

Short answer would be no. You'll find a B50 head but it will take time and it will cost you money. If you were to attempt fitting a B44 head, the amount of machining involved to bring it up to B50 specs would probably set you back even more money.