OzVMX Forum

Marque Remarks => Suzuki => Topic started by: pecker on January 04, 2014, 11:24:01 am

Title: 1982 RM 250z Jetting
Post by: pecker on January 04, 2014, 11:24:01 am

Hi all , rebuilding Z 250 motor bored , new carbie , exhaust , ignition , can I have the general spec's to get this carbie in tune . Thanks for all help Greg

Title: Re: 1982 RM 250z Jetting
Post by: suzuki59 on January 04, 2014, 05:11:00 pm

Hi Greg this is a question for D project he has a similar set up I do believe.

Title: Re: 1982 RM 250z Jetting
Post by: pecker on January 11, 2014, 01:45:12 pm

Thanks Craig i'll try to contact him .

Title: Re: 1982 RM 250z Jetting
Post by: D project on January 26, 2014, 05:44:15 pm

Standard specs are,
Needle 6FJ41 3rd groove
Main 290 but you can lean it out to 270
Needle jet Q-6
Pilot 50
Slide 4.0

Title: Re: 1982 RM 250z Jetting
Post by: suzuki59 on January 26, 2014, 06:52:05 pm

There you go pecker z-D project aka Jason is the RM guru,so his specs will see you right.

Title: Re: 1982 RM 250z Jetting
Post by: bazza on January 26, 2014, 07:05:21 pm

 Run Suzuki 59 carb settings but go up 200 on main jet ;D ;D ;D ;D :D :D :D :D ;) ;) ;) ;) :) :) :) :)

Title: Re: 1982 RM 250z Jetting
Post by: pecker on January 26, 2014, 08:52:48 pm

Thanks Jason , .