OzVMX Forum

Marque Remarks => Spaniards (Bultaco, Ossa, Montesa etc) => Topic started by: farmer58za on September 17, 2013, 05:45:02 am

Title: H6 Seal holder screws
Post by: farmer58za on September 17, 2013, 05:45:02 am

Hi All
On an H6 or late Cappra motor, Should the six countersunk screws holding each crank seal housing in place be secured with loctite?
Thanks
David

Title: Re: H6 Seal holder screws
Post by: Big John on September 17, 2013, 01:49:42 pm

I don't know if they should be, but I loctite them.

Title: Re: H6 Seal holder screws
Post by: Montynut on September 17, 2013, 02:10:43 pm

originally they had countersunk lock washers that you can not get for love nor money. I loctite them but with the weakest grade as getting them out is a bitch if you round the head. I usually replace the original slotted screws with countersunk allen head screws which are easier to drill off if required.

Title: Re: H6 Seal holder screws
Post by: farmer58za on September 17, 2013, 05:16:05 pm

Loctite it is!
Thanks
David