OzVMX Forum
Marketplace => eBay Finds => Topic started by: NGK on June 04, 2013, 11:01:24 pm
-
found this on ebay and thought someone might have a use for it?
http://www.ebay.com.au/itm/Yamaha-YZ175c-1976-New-Cylinder-/271213209582?pt=AU_Motorcycles&hash=item3f259127ee
-
I'm pretty sure that this [stud pattern] will fit all the way back to my AT1--which i actually have a TY175 cylinder on. Think i had to take about 5mm off the bottom of the liner as the TY ran into a step down in the c/case which damn near caught me out [would have been a 'big' air leak]. Apart from that it bolted straight on. digressing sorry [bad habit] but just saying should fit all the AT/CT/DT125-175A/B series motors [check out the base gasket visually, although numbers may change for other reasons like gasket composition etc]. Anyway--a bit of 'useless' information. Someone will put me right [if i'm wrong]. Now, clearing out junk & sold just sold 7 lawn mowers for $312.50, lawns are growing & for that price all the junky new mowers out there for that price range are worse than just about any one of my 7 bugger it. Wifes fault, 'i want a mower i can start'. Cheers.
-
for some reason this just comes to mind?
(http://i.imgur.com/kCmQuso.jpg)
-
God, looking at that mower pic makes me realize i was nearly heading that way [or am]--not to mention i had 5 Isuzu Bellet pushrod cars from 1968 [DT1 year again] rear wheel drive cars lined up down the drive, one with 25x8x12 quad tyres on good on the farm in the mud, got rid of them though [& got a Lada], i give up, i have an illness. ps, & have a tv in my farm car incase Coro Street starts before i get home.