OzVMX Forum

Clubroom => Tech Talk => Topic started by: jimg1au on May 14, 2008, 08:22:38 am

Title: CHECK TIMING ON DT360A
Post by: jimg1au on May 14, 2008, 08:22:38 am

hi
i have a dt360a and i need to check the timing.the manual says use a dial indicator but i dont have one.is there any other way of checking this.i am replacing the key in the crank.i have a puller to get the mag off.
cheers
jim

Title: Re: CHECK TIMING ON DT360A
Post by: Lozza on May 14, 2008, 12:21:22 pm

Give me a ring Jim,I'll talk you through it
Cheers

Title: Re: CHECK TIMING ON DT360A
Post by: pancho on July 31, 2008, 05:07:02 pm

g,day jim. you were asking about jet sizes for your 360 .i still havnt found  my book but i found another piece re-carby fitted to the rt2 model--- carby type-vm32sh mikuni i.d.mark-308e2....main jet-230.... needle jet 6dh3... clip pos 3... needle jet p-0.... cutaway3... pilot #45....starter jet #60... float level 21.4+-2.5mm ....also there is a rubber "o"ring on the bottom of the needle jet wich will make it run verry rich if not perfect  hope this may help cheers wally.