OzVMX Forum
Marketplace => Wanted => Topic started by: Kenneth S (222) on May 21, 2013, 02:15:50 pm
-
Hi Guys, I had an eventful weekend so need a few parts. If anyone has any of the following lying around in the shed, I'm buying,
79 CR250RZ
Stator assembly
Petcock assembly
Set of clutch & friction plates
84 CR250RE
Rear chain guide
Front brake assembly
Cheers,
Ken
-
Hi Ken
What part of the 84 front brake assembly do you need?
I have a full brake setup ready to bolt on from an 84 model. Thats caliper, line and master cylinder.
I also have a good set of 84 forks that are missing the lower bolts and the axle clamp and a front wheel complete with disc from an 86 model.
So a complete front end minus the bolts and axle clamp.
Cheers
Craig
-
I'll email you.
-
you need to specify which stator so that you get the right matck for your coil . it has a stamped letter on it.
-
all the internals of the stators are the same its only the stator cover that has different timing dowel locations but the guts are the same
-
Hi Ken
What part of the 84 front brake assembly do you need?
I have a full brake setup ready to bolt on from an 84 model. Thats caliper, line and master cylinder.
I also have a good set of 84 forks that are missing the lower bolts and the axle clamp and a front wheel complete with disc from an 86 model.
So a complete front end minus the bolts and axle clamp.
Cheers
Craig
Hi Craig,
Did you get my email? If not, can you email me the prices please? [email protected]
Cheers