OzVMX Forum
Marketplace => For Sale => Topic started by: HL400 on January 19, 2013, 08:04:28 pm
-
Huge CZ shed clean out sold as a job lot, CZ 380 Parts I have goon all Husky so these parts have to go.
2 – CZ 380 new piston kits 82.75mm
1 CZ 380 new piston kit 82mm
1 new set 82.50 Rings
1-new base gasket
1-new head gasket
2 new 13t front sprockets
1 –new 14t front sprocket
1 new 52t rear sprocket
1 new gear lever Falta copy
1 new kick starter spring
assorted lock tabs and bolts
1 clutch spring removing tool
1 clutch hub holding tool
1 flywheel puller
1 clutch nut tool
4 set new 35mm fork seals
1 cylinder. (needs a rebore)
1 complete fly wheel and point set (used)
1 air box with no dents
and assorted used bits and pieces.
$500.00 for the lot. ONO
-
Where are you located and is the barrel 5 stud or 6 stud
Thanks
-
its a 6 stud and the current bore is 82.75 but will need a rebore as its has a deep gouge on one side. HL
-
HL
Where are you what state ?
-
Huge CZ shed clean out sold as a job lot, CZ 380 Parts I have goon all Husky so these parts have to go.
2 – CZ 380 new piston kits 82.75mm
1 CZ 380 new piston kit 82mm
1 new set 82.50 Rings
1-new base gasket
1-new head gasket
2 new 13t front sprockets
1 –new 14t front sprocket
1 new 52t rear sprocket
1 new gear lever Falta copy
1 new kick starter spring
assorted lock tabs and bolts
1 clutch spring removing tool
1 clutch hub holding tool
1 flywheel puller
1 clutch nut tool
4 set new 35mm fork seals
1 cylinder. (needs a rebore)
1 complete fly wheel and point set (used)
1 air box with no dents
and assorted used bits and pieces.
$500.00 for the lot. ONO
that stuff would fit in a mid size box so hows it a huge shed clean out ;D
-
I am In Victoria, and OK Paul its a mid size but heavy sheed clean out ha ha HL
-
All sold HL