OzVMX Forum

Marque Remarks => Yamaha => Topic started by: allan hughes on October 02, 2012, 07:28:02 am

Title: YZ 250 A
Post by: allan hughes on October 02, 2012, 07:28:02 am

YZ250A FRONT FORKS
TO FIT TO YZ125A
I HAVE BEEN TOLD THIS IS ABLE TO DONE
ANY DRAMA THANKS

Title: Re: YZ 250 A
Post by: Davey Crocket on October 02, 2012, 07:35:18 am

You need YZA/B 250/360 forks, tripples, front wheel, brakes, brake cable.....just take the whole lot out of your 250.....you will need longer shocks aswell to make it work properly....360mm, cheers John.

Title: Re: YZ 250 A
Post by: Nathan S on October 02, 2012, 11:19:45 am

Quote from: Davey Crocket on October 02, 2012, 07:35:18 am

You need YZA/B 250/360 forks, tripples, front wheel, brakes, brake cable.....just take the whole lot out of your 250.....you will need longer shocks aswell to make it work properly....360mm, cheers John.

Yep. DT or MX250/360 parts are also a huge improvement over the stock 125 parts, while being much cheaper and easier to find than YZ250/360A stuff.
YZ125C bits also work and are legal - the upper tubes are the same as YZ-B, while the lower legs are the same as DT/MX-A. If you're a real fuss pot, there's a slight, non-performance difference between the YZ125C lowers and the earlier parts, but it would take a train-spotter to pick it. And a vindictive jerk to protest over it.

Title: Re: YZ 250 A
Post by: firko on October 02, 2012, 11:36:26 am

I fitted a complete MX250 front end including triples and the wheel to my MX125 with no problem, it's a bolt on.

Title: Re: YZ 250 A
Post by: Freakshow on October 02, 2012, 12:25:47 pm

you just need to fit the 34mm triples ( any yamaha model ) and fit what ever you like MX, YZ or what have you easy access to

Title: Re: YZ 250 A
Post by: allan hughes on October 03, 2012, 07:27:23 am

 
YZ125 A AND COMPLETE YZ250A FRONT END
DELIVERED TO IVAN AT TFB TODAY
THANKS AL