OzVMX Forum

Clubroom => Tech Talk => Topic started by: b490 on July 12, 2012, 10:48:47 pm

Title: Husky flywheel puller
Post by: b490 on July 12, 2012, 10:48:47 pm

 Need to purchase  flywheel puller to suit '79 Husky 390 engine  . (Motoplat )
Measured thread size @ 27mm x1.25 pitch ( R/H thread? ) .
Is this correct spec ?
 
Regards ,
              Steve

Title: Re: Husky flywheel puller
Post by: Montynut on July 12, 2012, 11:17:34 pm

There are three motoplat puller sizes

24mm (almost sure)
27mm
30mm all have 1.25mm thread

all available on ebay for little money and good quality from US search motoplat

where are you located?

Title: Re: Husky flywheel puller
Post by: b490 on July 13, 2012, 11:14:11 am

Quote from: Montynut on July 12, 2012, 11:17:34 pm

There are three motoplat puller sizes

24mm (almost sure)
27mm
30mm all have 1.25mm thread

all available on ebay for little money and good quality from US search motoplat

where are you located?

  Thanks ,

 Sydney location
 
 27mm X 1.25 looks to be the one  for '79 engine with Motoplat ign
 
 I am led to believe that  the later  models are equipped with SEM units ?

 
      Regards ,
           Steve

Title: Re: Husky flywheel puller
Post by: VMX60 on July 13, 2012, 12:59:54 pm

This Ebay seller in the UK  has these puller at a cheap price  last one I brought was under $15



Seller Ebay ID  fdosdesign

Cheers