OzVMX Forum

Marque Remarks => Spaniards (Bultaco, Ossa, Montesa etc) => Topic started by: huskibul on July 03, 2012, 10:01:32 am

Title: Pursang/mikuni jetting
Post by: huskibul on July 03, 2012, 10:01:32 am

    Wanted  72' 250 pursang / 36mm mikuni conversion baseline jetting specs - any info much apreciated  :)

Title: Re: Pursang/mikuni jetting
Post by: Matador107 on July 03, 2012, 05:41:10 pm

Go to club bultaco australia site and look up technical section,lots of carby info for Pursang/Mikuni set up there. Cheers.

Title: Re: Pursang/mikuni jetting
Post by: Moto on July 03, 2012, 06:04:31 pm

These are the settings from the CBA site Mk 6 250 Pursang 106 courtesy of Mark Austin

  Mikuni 36mm
Main      270
Pilot        35
N-Jet     Q-5  (159)
Needle     6DH3
Slide       2.5
Needle    Mid pos     

Title: Re: Pursang/mikuni jetting
Post by: huskibul on July 03, 2012, 06:41:01 pm

   Thanks for that moto & matador gives me a starting point - cheers  :)