OzVMX Forum

Marque Remarks => Honda => Topic started by: suzuki27 on May 14, 2012, 04:34:12 pm

Title: CR125M jetting
Post by: suzuki27 on May 14, 2012, 04:34:12 pm

Can anyone help with jetting specs for a 30-32 mm Mikuni round slide to be fitted to a 75 CR125?. Cheers.

Title: Re: CR125M jetting
Post by: suzuki27 on May 15, 2012, 07:05:06 pm

Was that a rude question or is it tightly held info?

Title: Re: CR125M jetting
Post by: bigk on May 15, 2012, 07:43:26 pm

Buy a new one (30mm if you have a stock engine), raise the needle clip one position (leaner), bolt it on and go racing. There are some other things to do make it a nice fit. Send your email and I will snd some photo's.
Cheers,
K

Title: Re: CR125M jetting
Post by: suzuki27 on May 16, 2012, 08:04:08 am

Thanks Big K.

Title: Re: CR125M jetting
Post by: 09.0 on May 30, 2012, 06:45:56 pm

The pre jetted 32mm from Scott steger is
240 main
45 pilot
6f21 needle
Middle clip
Needle jet 159 series p8
Slide 3.0

Title: Re: CR125M jetting
Post by: suzuki27 on May 31, 2012, 06:09:52 pm

thanks Brad. much appreciated.