OzVMX Forum

Marque Remarks => Spaniards (Bultaco, Ossa, Montesa etc) => Topic started by: Tahitian_Red on February 03, 2012, 04:16:43 pm

Title: 360 in a V75 frame?
Post by: Tahitian_Red on February 03, 2012, 04:16:43 pm

Will a 360 motor from a VA fit in a V75 frame?

Title: Re: 360 in a V75 frame?
Post by: cappra on February 03, 2012, 05:25:32 pm

The VA 360 motor will fit in the V75 frame as well as the VR's.

Title: Re: 360 in a V75 frame?
Post by: Tahitian_Red on February 04, 2012, 11:20:04 am

Second question, got one laying around?   ;D

Title: Re: 360 in a V75 frame?
Post by: cappra on February 04, 2012, 11:36:04 am

I have 3 v75 frames. 2 used, one NOS.

Title: Re: 360 in a V75 frame?
Post by: Tahitian_Red on February 04, 2012, 12:11:27 pm

Jared,

I got the frames, I was talking about the motor.  ;)

Title: Re: 360 in a V75 frame?
Post by: cappra on February 04, 2012, 01:24:39 pm

No 360's. Difficult motor to come by since they only made them one year. I have one that I'm making
a flat tracker out of. Of course you could buy my excellent condition VA 360 for $3600.00  :)

Title: Re: 360 in a V75 frame?
Post by: shortshifter on February 14, 2012, 03:01:12 pm

nice bike Jared.Was it the VA that had the clutch problems?

Title: Re: 360 in a V75 frame?
Post by: cappra on February 14, 2012, 03:28:04 pm

The early model 360's that had the clutch mounted on the crankshaft were problematic.
After mid year when the clutch was mounted on the primary shaft,end of problems.