OzVMX Forum

Marketplace => Wanted => Topic started by: nifty on January 12, 2012, 08:03:04 am

Title: Honda CR125M crank seal source
Post by: nifty on January 12, 2012, 08:03:04 am

Trying to locate an Aus source or anyone that may have a stock of crank seals to suit the Honda CR 125M engine, 1974. The seal I require is the 28 x 56 x 9, Honda part 91203-360-003.

Title: Re: Honda CR125M crank seal source
Post by: Noel on January 12, 2012, 09:18:30 pm

Hi Nev.
the last seals I got from Craig at MMT,
I think they were Pro x, the set before that from Red Devil had Kawasaki part numbers on them.
Hth.
Cheers
Noel

Title: Re: Honda CR125M crank seal source
Post by: Lozza on January 12, 2012, 11:31:17 pm

I have a Pro-X one here but it is by 8mm wide not 9mm

Title: Re: Honda CR125M crank seal source
Post by: nifty on January 13, 2012, 07:22:14 am

Thanks Noel & Lozza, I'll try Craig as I'll have to take the crank to him at any rate, snapped the pin in half at Buladelah, not sure why there was no heat stress evident!

Title: Re: Honda CR125M crank seal source
Post by: Shaun G on January 13, 2012, 09:30:12 am

Hey Nev I got my last set for the '76 off Bruce so maybe you could get them from Les now???
Cheers
Shaun

Title: Re: Honda CR125M crank seal source
Post by: nifty on January 15, 2012, 10:03:59 am

Shaun, Magoo supplied my last one as well, good thought, I'll try Les when he returns from holidays. Cheers.

Title: Re: Honda CR125M crank seal source
Post by: Stewart Allen on February 12, 2012, 02:08:37 pm

Hi Nev,
         I have a couple if you are still looking.

Cheers
Stewart

Title: Re: Honda CR125M crank seal source
Post by: bazza on February 12, 2012, 02:59:31 pm

"Econohonda" New Zealand