OzVMX Forum

Marque Remarks => Spaniards (Bultaco, Ossa, Montesa etc) => Topic started by: cappra on November 03, 2011, 05:15:47 pm

Title: Montesa magneto puller size
Post by: cappra on November 03, 2011, 05:15:47 pm

What size is the mag puller used on the 360 Enduro models?
It's not 27mm x 1.25 or 30mm x 1.5

Title: Re: Montesa magneto puller size
Post by: LWC82PE on November 03, 2011, 06:43:37 pm

have a look in the tools/workshop section here
www.mcsonline.com.au
They have various pullers and list the thread sizes. I know there are some for euro bikes there.


Also you can try here http://www.dssalesusa.net/ because thats where the MCS ones come from

Title: Re: Montesa magneto puller size
Post by: Mike52 on November 03, 2011, 07:33:40 pm

My H6/360 used a 27/1.25 puller , and I still have it. ;D

Title: Re: Montesa magneto puller size
Post by: BultacoMacca on November 03, 2011, 11:58:30 pm

(I could be real funny and say a Monty only needs a 10lb hammer to get any part off!!)

Title: Re: Montesa magneto puller size
Post by: Montynut on November 04, 2011, 12:04:59 am

I have always thought you where a BULLY :D ;D

Title: Re: Montesa magneto puller size
Post by: jurado on November 04, 2011, 12:06:15 am

360 h7 engines came out with two size versions:

33 x 1.50 mm – big flywheel
27 x 1.25 mm – small flywheel

Both available.

Title: Re: Montesa magneto puller size
Post by: cappra on November 04, 2011, 05:16:59 am

Thanks for the info. My supplier has them in stock.
The 33 x 1.50 is a MP #64. Fits Honda CN250 Helix Scooter models.

Title: Re: Montesa magneto puller size
Post by: Montynut on November 04, 2011, 10:36:31 am

My VG414 has a large flywheel with 33 x 1.5mm size puller required yet both my H6 360 engines have the same size flywheel but only the 30 x 1.5mm puller required?