OzVMX Forum

Marketplace => Wanted => Topic started by: steve7406 on September 27, 2011, 04:41:34 pm

Title: MX250 cdi
Post by: steve7406 on September 27, 2011, 04:41:34 pm

Looking for a hitachi cdi unit for my 75 mx250 or any other brand that will fit/work.

Title: Re: MX250 cdi
Post by: Freakshow on September 27, 2011, 05:28:37 pm

EBAy - they just keep coing up.

125/250/360/500 will all work, just the plugs change to more or less.

Title: Re: MX250 cdi
Post by: Freakshow on September 27, 2011, 08:58:23 pm

http://www.ebay.com.au/itm/180728028574?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

just need to put your own end connections on to suit.

Title: Re: MX250 cdi
Post by: steve7406 on September 28, 2011, 12:33:40 pm

Thanks Freakshow have made contact with seller .

Title: Re: MX250 cdi
Post by: asasin on September 28, 2011, 01:52:04 pm

I have just sucessfully put a KT 250 one on mine , it works well

Title: Re: MX250 cdi
Post by: steve7406 on September 28, 2011, 08:18:48 pm

asasin whats the availability on those units and is it hard to adapt.

Title: Re: MX250 cdi
Post by: asasin on October 01, 2011, 07:02:19 am

KT 250 ignition cdi was easy to find  and I was able to use a MX/DT pickup and rotor on the motor ( that bit was a bit hard to find) if you have a electo sparky or tech friend the hookup is not too hard, I can give you a drawing if you end up with these parts
 It is on a YZC 250 motor , gives it good low end response and gets the timing out before pinging in mid range