OzVMX Forum

Marque Remarks => Spaniards (Bultaco, Ossa, Montesa etc) => Topic started by: Colin Jay on August 27, 2011, 09:30:11 am

Title: Montesa Part Suppliers?
Post by: Colin Jay on August 27, 2011, 09:30:11 am

I have just stipped down the 1979(?) 247 Cota that I resently obtained, and have had to use a hacksaw to cut the through the seized swingarm pivot bolt and use a lot of heat to get all the bushings etc out of the swingarm. Is there a supplier here in Aust that can provide swingarm bushes etc for a Cota? Or can someone suggest a reliable overseas source?

Thanks,
CJ

Title: Re: Montesa Part Suppliers?
Post by: jimg1au on August 27, 2011, 12:10:36 pm

cappra on this fourm sells monty parts south west montesa

Title: Re: Montesa Part Suppliers?
Post by: shorelinemc on August 31, 2011, 10:56:47 am

contact hitatree

Title: Re: Montesa Part Suppliers?
Post by: Big John on September 01, 2011, 06:10:44 pm

Talk to Cappra on here AKA Jarard Bates, Sowthwest Montesa or John at Rocky mountain Montesa both in the US. Both good to deal with and very knowledgeable. Montesa parts are few and far between in Australia. You can get parts from Spain (Solo Montesa) is one, but you pay an and and leg for parts.

Title: Re: Montesa Part Suppliers?
Post by: Montynut on September 01, 2011, 06:13:50 pm

In motion trials in the UK is my third point of call for Cota parts if Jarred or John can not help.