OzVMX Forum

Marque Remarks => Spaniards (Bultaco, Ossa, Montesa etc) => Topic started by: farmer58za on July 17, 2011, 07:58:58 am

Title: Cappra 250 VB Primary drive
Post by: farmer58za on July 17, 2011, 07:58:58 am

Hi all
I'm busy with a rebuild on my 250VB motor. The parts handbook shows a flywheel of sorts (6660.036) at the primary gear. A later revision of the parts book shows no flywheel.

My motor has no flywheel: http://s215.photobucket.com/albums/cc198/farmer58za/?action=view&current=IMG_4448.jpg  although according to the engine numbers on the handbook, it should have one.

Can someone please advise whether the flywheel should be fitted.

Thanks in advance.
David

Title: Re: Cappra 250 VB Primary drive
Post by: mike1948 on July 17, 2011, 05:17:46 pm

I checked my V75 & VB parts books, they both show an auxiliary flywheel integral with the drive pinion.  I guess if it has previously been running without, shouldn't be a problem.  Most european bikes were fairly flexible with minor changes within model numbers.

Title: Re: Cappra 250 VB Primary drive
Post by: mx250 on July 17, 2011, 06:11:50 pm

I'm no Monty expert but I thought flywheel weight = enduro, no flywheel = MX. Otherwise the same.

Title: Re: Cappra 250 VB Primary drive
Post by: cappra on July 18, 2011, 02:13:24 am

Only the Enduro models used an aux flywheel on the primary side.

Title: Re: Cappra 250 VB Primary drive
Post by: farmer58za on July 18, 2011, 05:06:19 am

Thanks all!

Regards
David