OzVMX Forum

Marque Remarks => Husqvarna => Topic started by: 49 on June 16, 2011, 07:54:09 pm

Title: Husqvarna WR400 1986 Mikuni jet set up
Post by: 49 on June 16, 2011, 07:54:09 pm

Hey Guys,

Can anyone tell me the correct carby jetting set up for a round slide 38mm Mikuni for an Husky WR 400 1986.

Cheers
Col

Title: Re: Husqvarna WR400 1986 Mikuni jet set up
Post by: Mike52 on June 18, 2011, 01:20:09 pm

Hi Col
According to my 86 / WR400 data sheet.

Main Jet -------- 400
Needle Jet ------- Q6
Idling Jet ---------35
Needle position-----4 from top
Air jet -----------2.0
Needle---------6DH3
Airscrew --------1.5 turns out
Throttle --------2.5

Have fun ;D
Mike :)

Title: Re: Husqvarna WR400 1986 Mikuni jet set up
Post by: Slakewell on June 18, 2011, 01:41:20 pm

I had raced some of these back in the day and the hot tip to get them pulling of the bottom was to file more cut-away into the back of slide ( just 1mm at a time )

Title: Re: Husqvarna WR400 1986 Mikuni jet set up
Post by: 49 on June 18, 2011, 03:51:30 pm

Thanks Mike and Slakewell,

I will take carby off and get it sorted.

Cheers
Col

Title: Re: Husqvarna WR400 1986 Mikuni jet set up
Post by: Mike52 on June 19, 2011, 05:16:13 pm

That jetting would be a starting point only Col.


Mate is running a 430 main in his 84/ 240 Wr.

Cheers Mike.

Title: Re: Husqvarna WR400 1986 Mikuni jet set up
Post by: 49 on June 19, 2011, 05:27:07 pm

Hey Mike,

Tom Hatrick of Mikunioz sent down these spec :
I gather this is a 2 stroke in which case I'd expect the VM38 to run (1982 spec) with a 45 pilot, 6DH3, R4 and a 450 main.

I am getting the carby sorted out by someone in the know and that has heaps of Husqvarna knowlage.

Thanks for the feedback will let you know when I get it running right?

Cheers
Col