OzVMX Forum

Marque Remarks => Husqvarna => Topic started by: Kane Mcguire on April 19, 2011, 05:14:08 pm

Title: wanted husky 40mm forks/tripples
Post by: Kane Mcguire on April 19, 2011, 05:14:08 pm

want to put a set on my 1980 wr. ta.  [email protected]

Title: Re: wanted husky 40mm forks/tripples
Post by: Brian Watson on April 20, 2011, 10:32:18 am

Do you want a set from a CR with the "extended" lower section or the short ones from a WR?..

Title: Re: wanted husky 40mm forks/tripples
Post by: Kane Mcguire on April 20, 2011, 04:29:35 pm

either is ok cause i am mainly after the strength of the 40mm.

Title: Re: wanted husky 40mm forks/tripples
Post by: bigk on April 20, 2011, 08:37:21 pm

I have a few sets of forks, not sure about clamps though.
K