OzVMX Forum
Marque Remarks => CZ => Topic started by: mainline on April 13, 2011, 07:29:39 pm
-
early 70's vintage.
Not much to go off I know ;D
(http://i.ebayimg.com/00/$(KGrHqUOKiME13nrv!RZBNnW2B8mPg~~_12.JPG)
-
Geez Paul....Vandy (watch ya back) will give you shit over that....its fairly simple...does it have the same amount of holes...correct width..1.85 or 2.15...then its just the angle of the spokes (may have to be re-angled)...I take it it is the right size (18")....all it costs is money. ;D
-
thanks, I think ::) ;D
It's the right size, I just wasn't sure about the spoke angle. I don't have anything to compare it to and was hoping someone might know at a glance whether it looked right. If I have to re-drill it then fair enough. I have a spade bit that should do the job ;D
P.S. If you didn't have nanna naps while riding you wouldn't get run over ;)
-
Trust me, I was wide awake....the young wippersnapper couldnt take another beating. ;D
-
just stick a couple good fitting nipples innit,assuming CZ hubs fairly wide,you would need the spokes to splay outward some,if they're too vertical,then rims for smaller/narrower hub width,& they might also not angle forward/back far enough for large diameter hubs,or suit spool,or offset hubs??,careful with the reangling too ;), :P
-
well did you win it off e pay ???, :P
-
Nah, it sat on $50 for a week, then shot up to $240 at the end. Too rich for me