OzVMX Forum
Marque Remarks => Yamaha => Topic started by: wmc83 on February 26, 2011, 12:45:55 pm
-
I finally found a new inlet manifold for my yz125j it's a reproduction of the original but it has a tit for the boost bottle (which the 125j didn't have). Did the ever work? Because it would easy to fit one from a yz100 as they had the same plastics and a similar frame (also some works bikes ran them) or should I just cap it off.
-
I would put it on if you've got the bits. What have you got to lose ;)
Will look trick too 8), but depends if you are going for original look or not
-
I think I'll start looking around for one I don't need to change anything permanently to make it fit The pace I go it should be ready for cd8 :)